For which products do we need measurements?
- Stokke Trailz handle bar
- Stokke Crusi handle bar
- Stokke Scoot handle bar
Why you have to measure your stroller’s handle bar:
The dimensions of the handle bars foam varies, even on same models.
There are differences in length and circumference of up to 1cm.
Therefore it is important that you measure your own stroller, so we can tailor our products custom made for you.
How you measure your stroller:
We need the following dimensions:
– Length measured on the outside of the handle bars rounding
– Circumference (best measured at several points to see if it’s the same everywhere)
Best way to measure is with a measuring tape.
We need EXACT dimensions, so please don’t add or count off anything.
The exact size the covers must have to fit your stroller will be calculated by us according to your measurements.
The length of the finished covers will be slightly smaller than the dimensions of the handle bar/bumper bar. That’s because the leather will stretch during lacing and would be too long otherwise.
The lace-up covers will always be a bit thinner than the circumference you gave us – that’s because the covers have to be pulled over the bars very tightly during lacing, so they don’t slip later.
How to read the measuring tape properly:
The long lines always mark the cm steps.
It’s a bit confusing because the numbers often are written next to the shorter lines.
Don’t read the measuring from “the wrong side”.
In this example that means it’s not 11,6 cm but 10,4 cm.
The metall cap on the beginning of the measurig tape counts in.
So you start at the very beginning of the tape, not after the metal cap.
Also check if the first cm isn’t missing (sometimes it happens that the metal part tears appart or is cut off).
Right measurement for the handle on the picture: 10,4 cm
NOT right: 11,6 cm, 10,9 cm, 11,4 cm